Aastra Telecom 9480i Series - Manual (Page 894)

Operational, Basic, and Advanced Parameters
A-120 41-001160-03, Rev 00, Release 2.4
IP Phone Administrator Guide
Per-Line Settings
Parameter –
sip autodial timeout
Autodial Timeout
(in Web UI)
Aastra Web UI Advanced Settings->Global SIP->
Autodial Settings
Configuration Files aastra.cfg, .cfg
Description Globally specifies the time, in seconds, that the phone waits to dial a
preconfigured number after the handset is lifted from the IP phone
cradle.
If this parameter is set to 0 (hotline), the phone immediately dials a
preconfigured number when you lift the handset. If this parameter is set
to a value greater than 0, the phone waits the specified number of
seconds before dialing the preconfigured number (warmline) when you
lift the handset.
Default is 0 (hotline).
Format Integer
Default Value 0
Range 0 to 120
Examples sip autodial timeout: 30
Parameter –
sip lineN autodial number
Autodial Number
(in Web UI)
Aastra Web UI Advanced Settings->LineN->Autodial Settings
Configuration Files aastra.cfg, .cfg
Description On a per-line basis, this parameter specifies the SIP phone number that
the IP phone autodials when the handset is lifted from the phone cradle.
Valid values can be:
-1 (Default) The phone uses the global
autodial setting for this line.
Blank (Empty field) Disables autodial on this line.
Valid SIP Number Dials the SIP number specified for this line.
Format Integer
Default Value -1
Range Any valid SIP number.
Examples sip line1 autodial number: 8500
Draft 1