Avaya IP Office Phone - Manual (Page 61)

Safety and Homologation Statements Regulatory Instructions for Use - Page 61
IP Office Installation Manual Safety and Homologation Statements - Page 61
40DHB0002USCL – Issue 9 (28th October 2003) Regulatory Instructions for Use
Regulatory Instructions for Use
Any changes or modifications not expressly approved by Avaya ECS Ltd could void the
user's authority to operate the equipment.
IP Office Operation in Australia
Connection
Connection of IP400 Office products must be via a Line Isolation Unit with a
telecommunications compliance label.
BRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing
the following:
Short Code: "000"
Telephone No.: "000;"
Function: "Dial Emergency"
Connections to TS013, the following Bearer Capabilities shall not be used:
7kHz Audio
Video
Restricted Digital Information
If unknown type of number is used in calling party number, the network will use the default
CLI.
The system must be configured for Point to Multi point connection to comply with Austel
requirements for connecting to TS013 circuits.
As the IP Office does not support emergency dialing after loss of power, the following
warning notice should be recognized:
WARNING
This equipment will be inoperable when mains power fails.
PRI Interface
During the configuration, ensure "000" emergency number is not barred, by performing
the following:
Short Code: "000"
Telephone No.: "000;"
Function: "Dial Emergency"
WARNING
This equipment will be inoperable during mains power failure.
IP Office Operation in Canada
Industry Canada Notification (DoC)
This equipment meets the applicable Industry Canada Terminal Equipment Technical
Specifications. This is confirmed by the registration number. The abbreviation, IC, before
the registration number signifies that registration was performed based on a Declaration of
Conformity indicating that Industry Canada technical specifications were met.
It does not imply that Industry Canada approved the equipment.
''NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is 1. The
REN assigned to each terminal equipment provides an indication of the maximum number
of terminals allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers of all the devices does not exceed five.''