Expansion modules, Ip400 digital terminal 16/30, Front view (30 port version) – Avaya IP Office Phone User Manual
Page 23: Port connections, Rear view (all versions), Cables, Functional earth
Expansion Modules
IP400 Digital Terminal 16/30 - Page 23
IP Office Installation Manual
Expansion Modules - Page 23
40DHB0002USCL – Issue 9 (28th October 2003)
IP400 Digital Terminal 16/30
Expansion Modules
Dependent upon configuration requirements, combinations of the following Expansion
Modules are used with IP Office platforms. With the exception of the WAN3 module (see
page 26), all of these Expansion Modules are connected to the Expansion Ports of an IP
Office platform using Expansion Interconnect Cables (see page 73).
IP400 Digital Terminal 16/30
Front View (30 Port version)
Unit Status LED
Red = Alive but not initiated
Green = Running OK
DT Ports 9 - 16
DT Ports 25 - 30
Green LED
Connection OK
Yellow LED
(not used)
DT Ports 17 - 24
DT Ports 1 -8
Note: The IP400 Digital Terminal 16 Expansion Module is only equipped with the
bottom row of ports (1-16).
Port connections
• DT ports are used for connection to Avaya 2000 series telephones (see page 5) and
support either A-Law or
µ-Law PCM encoding. Both DT and DS ports can be set for
either
µ-Law or A-Law PCM encoding. At default both types of port are set to µ-Law but
can be switched, in software, to A-Law (refer to the Administration Manager Manual for
details).
Using DT Line Cords (see page 68) and standard structured wiring, these RJ45 ports
can be extended to the required telephone location. In addition, converters can be
used to provide BT New Plan sockets (431A/631A) if required (see page 77). When
devices are equipped with line cords that terminate in RJ11 plugs, then RJ11/RJ45
adapters should be used.
Rear View (all versions)
EXPANSION
DTE
Expansion Port
DTE Port
DC Power I/P Socket
DC I/P
- C +
24V DC
2A
Port connections
• Expansion Port: Used to connect a Digital Terminal Expansion Module to the
Expansion Port of an IP Office platform.
• DC Power I/P Socket: Socket for the external 24V DC unregulated power supply
(supplied with kit).
• DTE Port: A 25-way D-type socket. Used for connection to PC (diagnostics only).
Cables
All IP400 Office Digital Terminal/Digital Station variants are supplied with one blue
Expansion Interconnect cable. For Port Pinouts and Cables, refer to pages 63 and 67
respectively.
Functional Earth