Konica Minolta QMS magicolor CX Reference - Manual (Page 80)

The Sheet Feeder
QMS magicolor CX Reference Guide 2-6
3 Install the two small metal brackets using the following pro-
cedure:
a Align one of the metal brackets with the outside of the metal
post on the front right side of the sheet feeder. Make sure the
holes on the post and bracket are centered and that the
flange on the bottom of the bracket goes into the slot on the
post.
b Attach the bracket to the post using one of the two small
metal screws that came with the sheet feeder.
c Align and attach the second metal bracket to the rear left
sheet feeder post in the same way as you did the first bracket.
Metal Bracket
Rear Left
Metal Bracket
Rear Left
Metal Bracket
Front Right