Konica Minolta QMS magicolor CX Reference - Manual (Page 69)

Administration
Menu
1-61 Printer Configuration
Image Alignment
This option allows you to adjust the horizontal and vertical placement
of printed images. To check image alignment, print a standard status
page (Administration/Special Pages/Print Status). When the printer is
placing images properly, the alignment angle bar in the lower-left cor-
ner of the status page is 0.5"/12.7 mm from the left and bottom edges
of the page. If the angle bar is off, use the Administration/Engine/
Image Alignment option to align the image horizontally and vertically
in pixel increments (1/300" or 0.08 mm). Engine constraints may limit
the accuracy of pixel alignment.
Horizontal Offset
Menu
Administration
Engine
Image Alignment
Horiz Offset
Choices
000-300 (0.00"/0 mm-1.00"/25.4 mm)
100 (0.33"/.84 mm) (default)
Notes: Values above 100 move the image to the right. Values below 100
move the image to the left.
Vertical Offset
Menu
Administration
Engine
Image Alignment
Vertical Offset
Choices
000-300 (0.00"/0 mm-1.00"/25.4 mm)
100 (0.33"/.84 mm) (default)
Notes: Values above 100 move the image down. Values below 100 move
the image up.
Default Paper
Default Paper is used when the default media is requested but the
default input bin is missing from the engine so there’s no way to
sense the media size automatically.
Menu
Administration
Engine
Default Paper
Choices
Letter (default), A4