Konica Minolta QMS magicolor CX Reference - Manual (Page 166)

Updated DOC
Commands
QMS magicolor CX Reference Guide 3-32
Notes The result of various settings for these parameters is
shown in table below, in terms of the equivalent code
passed to the PCL line termination command
(
&k#G ). The second setting (lfiscrlf on, criscrlf
off) is correct for most ASCII listings printed from
UNIX machines. PC listings should usually be done
with both items set to off, and Macintosh listings
usually require the third setting (lfiscrlf off, criscrlf
on). The following table shows the criscrlf/lfiscrlf
commands and the corresponding PCL Line
Termination command parameters.
LFISCRLF CRISCRLF PCL Code Comments
Off Off 0 CR → CR,LF → LF,FF → FF
On Off 2 CR
→
CR,LF
→
CR-LF,FF
→
CR-FF
Off On 1 CR → CR-LF,LF → LF,FF → FF
On On 3 CR
→
CR-LF,LF
→
CR-LF,FF
→
CR-FF