Konica Minolta QMS magicolor CX Reference - Manual (Page 129)

Updating System
Software
2-55 Printer Options
4 Set the PC’s baud rate to 38400 by typing
modex.exe
↵
modex # 38400 n 8 1
↵
where # is 1-4. See the MODEX.DOC file for more information on
this program.
5 Turn on the printer, wait for IDLE to appear in the message
window, and then print an advanced status page.
This procedure should not change the current configuration set-
tings. However, the advanced status page provides a record of all
current configuration settings, so you can verify that they are the
same after the system software has been updated.
6 Take the printer off line.
7 Turn on the RTS and CTS hardware flow control settings.
a Access the Administration/Communications/Serial/Hdwe
Flow Ctl menu.
b Set RTS to On.
c Set CTS to On.
d Press the Online/Offline key to be prompted to save your
changes.
e Select Yes to Save Changes.
8 Access the Administration/Miscellaneous/New Flash Image
menu.
9 Select Yes in the New Flash Image menu.
The printer waits for the new system software (image) to be sent
via your PC’s parallel port. (
YES remains in the message window
until the new image is sent.)