Aastra Telecom M760E - Manual (Page 11)

Description
5
Once you have disconnected then reconnected the telephone
line (see page 2),
the display shows the software version of the set:
The display then shows the idle screen.
You have 5 seconds to carry out the following operation.
1 - Consecutively press , and keys.
The display asks if you wish to set up the attendant mode:
2 - Press Class.A or Class.B (example Class.B).
Note: this choice will depend on the system installed; please
consult your system operator for more information.
The display shows the idle screen in attendant mode.
Your M760E is configured in attendant mode and allows you
to access all management features*.
You can then activate the set (see page 14).
Class.B
Cancelling the attendant
mode configuration: You have deactivated the attendant set (ON/OFF programmed
key). Follow the aforementioned procedure, i.e.
- disconnect then reconnect the set,
- consecutively press
, and .
The display asks if you wish to set up the attendant mode.
- Press No / Non .
Your M760E is no longer in attendant mode.
The system associated with your M760E allows the operator to
cancel attendant mode on your set automatically. When
connected to a line not dedicated to the operator function, the
M760E gives you access to a whole range of features, such as
directories and call logs.
M760E
__RX.XXXX__
ATTENDANT CONSOLE/POSTE OPERATEUR ?
No / Non Class.A Class.B
No / Non
* Depending on the features provided by your system operator