Asus TW510-E2 User Manual

Page 78

C h a p t e r 4 : M o t h e r b o a r d i n f o

4 - 1 4

1 2 .

1 2 . Chassis intrusion connector (4-1 pin CHASSIS1)

C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )

This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.

1 3 .

1 3 . Front panel audio connector (10-1 pin FP_AUDIO1)

F r o n t p a n e l a u d i o c o n n e c t o r ( 1 0 - 1 p i n F P _ A U D I O 1 )

F r o n t p a n e l a u d i o c o n n e c t o r ( 1 0 - 1 p i n F P _ A U D I O 1 )
This connector is for a chassis-mounted front panel audio I/O module
that supports legacy AC ‘97 audio standard. Connect one end of the
front panel audio I/O module cable to this connector.

K8N-DL

CHASSIS1

(Default)

+5VSB_MB

Chassis Signal

GND

K8N-DL Chassis intrusion connector

K8N-DL

FP_AUDIO1

BLINE_OUT_L

MIC2

Line out_R

Line out_L

BLINE_OUT_R

MICPWR

+5VA

AGND

K8N-DL Front panel audio connector