Asus TW510-E2 User Manual

Page 37

2 - 1 9

A S U S T W 5 1 0 - E 2

2.7.2

Installing an internal SATA HDD

Your package comes with specially designed hard disk drive rails if you want
to install the hard disk drives internally (not hot-swap). Depending on which
bay you wish to install your hard disk drive, the orientation of the drive rails
vary so that the screw holes match those on the drive.

For identification purposes, the drive rails are referred to as “Rail 1” and
“Rail 2” as shown below.

Installing a SATA hard disk drive to the first hard disk

Installing a SATA hard disk drive to the first hard disk
drive cage

drive cage

To install a SATA hard disk drive to the first hard disk drive cage:

Remove the front panel assembly. Refer to section 2.5.1 for
instructions.

Use a Phillips (cross) screwdriver to attach R a i l 1

R a i l 1

R a i l 1 to the side of the

drive as shown. The rail end should be on the side of the drive
connectors.

Take note of the correct orientation of the drive rails. There is only one
c o r r e c t

c o r r e c t

c o r r e c t way to attach the rails when installing drives on the hard disk
drive cage.

R a i l 1

R a i l 2

R a i l h a n d l e

H o l e 1

H o l e 2

H o l e 3

H o l e

H o l e
4

H o l e 1

H o l e 3

R a i l

R a i l
h a n d l e

h a n d l e

D r i v e c o n n e c t o r s