Asus TW510-E2 - Manual (Page 21)

2 - 3 2 - 3 2 - 3 2 - 3 2 - 3 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2
2.1.2 2.1.2 2.1.2 2.1.2 2.1.2 Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover Reinstalling the side cover
To reinstall the side cover:
1. Align the cover rail with the
chassis rail (A), then match and
insert the cover top hooks to
the elongated holes on the side
of the chassis (B). All the four
hooks must properly fit the
designated holes.
2. Slide the cover toward the front
until it snaps in place.
3. Push down the chassis lock to
secure the side cover.
You may need to remove some of the installed components to access
the DIMM sockets and internal connectors. Refer to section “2.10
Removable components” for instructions.
Viewing the internal structure Viewing the internal structure Viewing the internal structure Viewing the internal structure Viewing the internal structure
Without the side cover, the internal structure and installed components of
the barebone server vary depending on the model you purchased. Refer to
section “1.5 Internal features” for the different model configurations.
Perform the procedures in the succeeding sections to install the CPU,
system memory, disk drives, and expansion cards; replace fans and power
supply; and connect the system cables.
A A A A A
B B B B B
2 2 2 2 2
3 3 3 3 3