Asus TW510-E2 - Manual (Page 129)

A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 A S U S T W 5 1 0 - E 2 6 - 3 6 - 3 6 - 3 6 - 3 6 - 3
6.1.1 6.1.1 6.1.1 6.1.1 6.1.1 Installing hard disks Installing hard disks Installing hard disks Installing hard disks Installing hard disks
The motherboard supports Ultra DMA 100/66 IDE and Serial ATA hard disk
drives. For optimal performance, install identical drives of the same model
and capacity when creating a disk array.
Installing Parallel ATA hard disks Installing Parallel ATA hard disks Installing Parallel ATA hard disks Installing Parallel ATA hard disks Installing Parallel ATA hard disks
To install IDE hard disks for a RAID configuration:
1. Set the jumpers of each hard disk as Master/Master or Slave/Slave.
2. Install the hard disks into the drive bays.
3. Connect the HDD signal cables.
4. Connect a 4-pin power cable to the power connector on each drive.
Installing Serial ATA (SATA) hard disks Installing Serial ATA (SATA) hard disks Installing Serial ATA (SATA) hard disks Installing Serial ATA (SATA) hard disks Installing Serial ATA (SATA) hard disks
To install the SATA hard disks for a RAID configuration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
Refer to the RAID controllers user manual on the support CD for detailed
information on RAID configurations.
6.1.2 6.1.2 6.1.2 6.1.2 6.1.2 RAID configuration utility RAID configuration utility RAID configuration utility RAID configuration utility RAID configuration utility
You can create a RAID set using the utility embedded in each RAID
controller. For example, you can use the N V I D I A
N V I D I A N V I D I A N V I D I A N V I D I A ® ® ® ® ® R A I D U t i l i t y R A I D U t i l i t y R A I D U t i l i t y R A I D U t i l i t y R A I D U t i l i t y if you
installed SATA hard disk drives on the SATA connectors supported by the
NVIDIA CK-04 Southbridge. Refer to the succeeding sections for details on
how to enter the RAID configuration utility.