beautypg.com

Search – Sony SVL24145CXB User Manual

Page 312

background image

6. If there is no free slot, remove the currently installed memory module. Pull the latches

in the direction of the arrows to pop up the module at an angle (1), then pull the

module out in the direction of the arrow (2).

7. Remove the new memory module from its antistatic bag.
8. Hold the memory module by its edge and slide it into the memory module slot with its

end terminal facing downward while aligning the notch on the module with the small

projection in the slot.

If you intend to install only one memory module, be sure to install it into the lower slot.

9. Hold the memory module by its edge and push in until it clicks into place as shown in

the illustration.

The latches on both sides of the slot snap into place to secure the module. Do not

touch any ICs (black components) on the memory module.

10. Replace the memory module compartment cover and secure it with the screws you

removed in step 3.

11. Reattach the back panel to your computer.

Note

Insert the tabs of the panel in the slots, and press it down until you hear a click.

12. Connect all connection cables and peripherals that you removed in Step 1, and turn on

the computer.

13. Check that the amount of system memory has correctly changed.

[Details]

If the amount of indicated system memory is correct, memory module installation was

successful.

Related Topic

312

Search

This manual is related to the following products: