HID Prox Programmer Installation Guide - Manual (Page 8)

Page 5
HID ProxProgrammer Operation Manual 1050-904 Rev B
1. When selecting a COM Port screen appears, click on the COM port where you have the HID Field
Programmer attached.
2. Once you have selected the correct COM port, the bar at the top of the dialogue box will indicate
that the COM port is available.
3. If the program indicates that no COM port is available, refer to
Troubleshooting COM port
selection on page 18. Click OK. The programmer will beep once if it is properly connected and
communicating with the COM port .
4. After the HID ProxProgrammer is initialized, you will be prompted to present the ICC (Intelligent
Control Card).
Getting Started
Selecting a COM Port