HID Prox Programmer Installation Guide - Manual (Page 6)

Page 3
HID ProxProgrammer Operation Manual 1050-904 Rev B
Customer Configuration
The HID Field Programmer software system is customized for each customer. The system file sysdb.sys
contains validation keys for each specific customer and their HID Field Programmer hardware. Once
Customer Specifics have been installed, the programmer and the software system should be ready to go.
IMPORTANT NOTE :
Be sure to make a backup of the following files:
ICCDB.SYS
SYSDB.SYS
If your system crashes, you will need these files to restore your customer card format information.
Introduction
1. Insert the
HID Field Programmer Customer Specific Floppy into the disk drive. At the Start
menu select RUN and type
A:\ Install.bat.
2. The batch file assumes that the target system hard drive is C:. If the assumption is incorrect, edit the
batch file,
Install.bat and replace the C: with the appropriate designator before executing the batch
file.
3. The DOS shell that executes the batch file will indicate that files have been copied.
4. Close the DOS shell. The software has been successfully installed.