4 - install reader to backplate, 5 - contact, Install to backplate – HID EDGE EVO EH400-K Standard Controller Installation Guide User Manual

Page 9: Contact, Standard networked controller

82000-921 C.0

INSTALLATION GUIDE

Standard Networked Controller

EH400-K

Contact EDGE EVO through one of the following methods.

5.1 Direct Connect

If EDGE EVO will be connected to a network using static IP addressing or if the Discovery GUI is not installed on the PC, use this

method.
Note: The computer must be running Windows 2000 or XP and be configured for DHCP.

1. Disconnect the computer from the network and directly connect EDGE EVO to the computer with an Ethernet cable.
2. Click

Start > Run. Enter ipconfig /renew ↵

3. Access a web browser and enter

169.254.242.121 into the Address field ↵

5.2 OPIN Discovery/Update Application

Use the

OPIN Discovery / Update Application on a computer to locate, connect and update EDGE EVO.

System Requirements:

Java 6.0 or later. Go to

www.java.com

to download.

Operating Systems:

Windows XP and Fedora 8.

Find the OPIN Discovery / Update Application at

www.ShareMethods.com

OPIN > Firmware > 2.3.x. Save the files to your

local harddrive.

Install to Backplate

Contact