American Power Conversion 10-30 KVA - Manual (Page 35)

990-1598B Smart-UPS® VT 10-30 kVA, 208/220 V Site Preparation and Installation Manual 29
 Loosen the (4) M4 screws (2 each side) from the bottom part of the Conduit Box and remove.
 Punch 2 holes in the marked areas of the Conduit Box bottom to fit the size of the conduit pipes,
and reattach the Conduit Box bottom to the Enclosure, re-using the (4) M4 screws.
 Install conduit pipes in the Conduit Box.
 Run cables through the conduit pipes and the bottom of the Conduit Box, pull behind the bar
and up into the input/output area.
 Reinstall the top part of the Conduit Box to the Enclosure, following reverse installation
procedures.
 Attach input cable lugs to L1, L2 and L3 input busbars (left side in the UPS – on the front of the
busbar), using the provided M6 torx screws. Attach output cable lugs to L1, L2 and L3 output
busbars, using the provided M6 torx screws. Attach N x 2 where shown, using the provided torx
screws.
 Attach Ground x 2 where shown, using the provided torx screws.
 Fasten cables with cable ties.
 Reinstall rear cover.
L
1
L
1
L
2
L
2
L
3
N
L
3
N
Ground
cables
Mains
input
cables
Neutral







Neutral
Output
cables

