American Power Conversion 10-30 KVA - Manual (Page 25)

990-1598B Smart-UPS® VT 10-30 kVA, 208/220 V Site Preparation and Installation Manual 19
Leveling Feet
Setting the leveling feet
Set the leveling feet to ensure the UPS is horizontal when it is in its final operating position. Use a 13/
14-mm wrench (shipped with UPS) to adjust all 4 leveling feet from front to back, and left to right,
until the pads make solid contact with the floor. Use a bubble level to check the Enclosure is
horizontal.
Note
Verify that the installation has been electrically wired before setting the leveling feet.
CAUTION!
To avoid equipment damage, do not push or pull the UPS after the leveling feet have
been lowered.
When the Leveling Feet have been set, remember to reinstall the Front Panel.
See Front Panel section.
13/14-mm wrench