Blodgett Mark V-100 XCEL - Manual (Page 10)

8
Installation
electrical connection
Wiring diagrams are located in the control compartment
and on the back of the oven.
The electric motor, indicator lights and related switches
are connected to the oven as follows:
1. Remove the bottom trim and control panel covers.
Slide the control panel forward.
2. Connect the supply conduit to the wire duct located
in the lower left hand corner on the back of the oven.
3. Run the supply wires through the duct to the front of
the oven.
4. Connect the supply wires to top of right contactor in
the control compartment at the lower right corner of
the oven.
5. Reinstall the bottom trim and control panel covers.
NOTE: To prevent damage there is no power to the
heating elements when the blower is not operat-
ing.
THE BLODGETT OVEN COMPANY CANNOT ASSUME
RESPONSIBILITY FOR LOSS OR DAMAGE SUFFERED
AS A RESULT OF IMPROPER INSTALLATION.
Install incoming
power on this
contactor
Figure 7