Hubbardton Forge 346013 - Manual (Page 3)

Installation Instructions
G3
For Outdoor Fixtures 346013 & 346013F Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
14940 Rev C
Component Parts
Note: Fixture, Post and Cover Cap each sold separately.
K Glass
L Retaining Ring (2)
M Glass Shield
N Threaded Socket
To Install (Figure 3)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Position Glass Shield (M) over Threaded Socket (N)
and secure with the two Retaining Rings (L).
2. Install 150-watt max type A light bulb and glass (K).
3. Note: The glass is mouth blown. Minor irregularities, including
being slightly out of square, are normal. It may be necessary to
turn the glass in relation to the fixture to achieve a good fit.
4. Restore electricity to breaker.
( Figure 3 )
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture