Hubbardton Forge 344820 - Manual (Page 2)

Assembly & Installation Instructions
G10
For Post-Mounted 34-4820 & 34-4820F Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22747
(Figure 3)
To Install Glass (Figure 2)
Component Parts
I Inner Glass
J Outer Glass
K Glass Cage
L Retaining Ring (2)
N Socket
1. Remove retaining rings (L) from socket (N). Retaining Rings are shipped
installed.
2. Slip outer glass (J) over socket (N).
3. Slip glass cage (K) over socket (N).
4. Thread first retaining ring (L) onto socket until it rests on bottom of outer glass (J).
Thread second retaining ring onto socket until it is snug against first retaining ring.
Do not over tighten.
5. Install bulb. (Fluorescent versions bulb is included.)
6. Slip inner glass (I) over socket (N) and bulb.
To Install Top Hat (Figures 3 & 4)
Component Parts
J Outer Glass
K Glass Cage
M O-Ring (2)
O Top Hat
P Threaded Stud
Q Flat Head Screw (4)
R Top
Cover
S Finial
T Cover
Plate
1. Disassemble upper assembly by unthreading finial (S) (Figure 3).
2. Install cover plate (T) aligning the four holes with the four standoffs so it
rests on top of glass cage (K).
3. Place top hat (O) on top edge of outer glass (J) and align holes in top hat (O)
with standoffs in glass cage (K).
4. Install four flat head screws (Q) and tighten.
5. Slip top cover (R) over threaded stud and let rest on the top hat (O).
6. Slip two o-rings (M) onto threaded stud (P).
7. Thread finial (S) onto threaded stud (P) until snug against top cover (R).
Align as shown if figure 3.
8. Restore electricity at main breaker.
(continued)
(Figure 2)
(Figure 4)