Hubbardton Forge 306007 - Manual (Page 2)

Installation Instructions
B109
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19767 Rev A
For Direct Wire Fluorescent Wall-Mounted Wet-Location Fixtures Page 2 of 2
To Install Glass (Figure 2)
Component Parts
F Socket
G Glass
H Retaining
Ring
I Bulb (provided)
1. Unthread retaining ring (H) from socket (F) and save for later use.
2. Place glass (G) over socket (F).
3. Thread retaining ring (H) on to socket (F) until snug against top of glass (G).
Be careful not to over tighten.
4. Install light bulb (I).
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)