Hubbardton Forge 305895 - Manual (Page 2)

Installation Instructions
B157
For Outdoor Sconces 30-5895 & 30-5895F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22216 Rev A
To Install Glass (Figure 3)
Component Parts
A Fixture
I Glass
J Thumb Screw (2)
K Bracket
1. Remove bracket (K) from fixture (A) by removing two
thumb screws (J). Set all parts aside for later use.
2. Install light bulb. (Fluorescent fixtures are supplied with
bulb.)
3. Slide glass (I) into fixture (A).
4. Attach bracket (K) onto fixture (A) with two thumb screws
(J). Do not tighten thumb screws at this point.
5. Adjust bracket (K) until it rests on top of glass (I).
6. Tighten by hand thumb screws (J) until snug against bracket
(K) (be careful not to over tighten).
7. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)