Hubbardton Forge 305605 - Manual

Installation Instructions
B163
For Outdoor Wall sconce 30-5605 & 30-5605F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22462
For fixtures requiring assembly, please refer to assembly instructions
before installation.
To Install Fixture (Figures 1, 2 & 3)
Component Parts
A Crossbar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking
Lip
F Screws (3)
G Retaining Ring (2) (“F” version has only 1 retaining ring)
H Spider
Assembly
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Remove glass retaining rings (G) and save for later use.
Note – “F” version only has one retaining ring.
3. Loosen screws (F) so that spider assembly (H) will turn clock wise. It is not
necessary to completely remove screws (F) from fixture. Once spider
assembly (H) is loose turn until it slips over the heads of the screws. Set
aside for later use (Figure 2).
4. Using two machine screws (not provided) attach cross bar (A) to the electric
box using inside oval holes to orient fixture.
Note: A new electric box comes with screws. When replacing a fixture,
retain the screws for use with the new fixture.
5. Start threaded studs (B) into appropriate holes in crossbar (A).
6. Using suitable wire connectors (not provided), connect the fixture wires to
the supply wires, (white to white, black to black, bare copper or green to bare
copper or green). If the fixture is wired with twin lead lamp cord, connect the
ribbed side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on securely and no bare
wires are exposed.
7. Apply a generous bead of a suitable caulking material to caulking lip (E) on
the fixture.
8. Carefully tuck all wires behind the fixture. Place fixture (C) over threaded
studs (B) and tighten firmly to mounting surface using barrel knobs (D).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)
(Figure 3)