Hubbardton Forge 126753F - Manual (Page 2)

Assembly & Installation Instructions
A141
For Impressions Semi-Flush 12-6750F & 12-6753F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21150
To Install Glass (Figure 2)
Component Parts
F Socket
G Bulb
H Glass
I Spider
Assembly
J Retaining Ring
K Diffuser
1. Place glass (H) into notches of spider assembly (I).
2. Lift glass (H) and spider assembly (I) over socket (F) until it stops.
3. Thread retaining ring (J) on to socket (F) until it rests against the bottom of
the spider assembly (I).
4. Install light bulb (G).
5. Insert the diffuser (K) up into the fixture at an angle then level it and gently
lower onto the lowest tabs of the spider assembly (I).
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)