Hubbardton Forge 126754 - Manual (Page 2)

Installation Instructions
A49
For Semi Flush Pendants with Twist Locking Mechanism Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
15636 Rev A
To Install Glass (Figures 2 & 3)
Component Parts
K Bands (3)
L Glass
M Screws
(3)
N Hooks (3)
1. Attach bands (K) to glass (L) by placing band sections around lip of glass and securing with countersunk
screws (M) (Figure 2).
Note: One hole is threaded and the other is not. Screws must go through the unthreaded hole then into the
threaded hole.
2. To attach glass to fixture, position glass around sockets and place the loops of the bands (K) over the hooks (N)
on the fixture (Figure 3).
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 2
Figure 3