Hubbardton Forge 126709 - Manual (Page 2)

Installation Instructions
A2
For Semi-Flush Mount Fixtures Page 2 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions prior to installation.
Component Parts
A Canopy
B Electric Box Machine Screws (not provided)
C Black or Smooth Wires
D Ground Wires
E White or Ribbed Wires
F Round Cross Bar
G 8-32 Threaded Studs
H 8-32 Knurled Balls
I Wire Nuts or connectors (not provided)
J Green Ground Screw
To Install
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (G) through appropriate holes in cross bar (F) to match
hole centers in canopy (A). Move ground screw (J) to another
available threaded hole if necessary.
3. Using two machine screws (B, not provided) fasten cross bar to the
electric box using outer oval holes to orient fixture to desired
hanging position.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.
5. Using suitable wire connectors (I) (not provided), connect fixture
wires to supply wires (white to white or ribbed (E) and black to black
or smooth (C). Connect all ground wires (D) to green ground screw
(J).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Slide fixture canopy (A) over threaded studs and push firmly to
ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with knurled balls (H). Be sure studs (G)
are fully seated in the knurled balls (H).
7. Install light bulb(s) (not provided).
8. Install glass (refer to glass installation instructions if appropriate).
9. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15658