Hubbardton Forge 124252 User Manual
A222, Installation instructions

Installation Instructions
A222
For Moonband Semi-Flush 12-4252 & 12-4253
Page 1 of 2
Hand-Forged,
Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
23181
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install Fixture
(Figure 1)
Component Parts
A Crossbar
B Ground
Screw
C
Threaded Stud (2)
D Canopy
E
knurl Balls (2)
Caution: Be sure power is off at the main breaker box prior
to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar
(A) to match hole centers in canopy (D). Move ground
screw (B) to another available threaded hole if
necessary.
3. Using two machine screws (not provided) fasten cross
bar (A) to the electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with screws. When
replacing an existing fixture, retain the screws for use
with the new fixture.
5. Using suitable wire connectors (not provided) connect
fixture wires to supply wires (white to white or ribbed
and black to black or smooth. Connect all ground wires
to green ground screw (B).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Slide fixture canopy (D) over threaded studs and push
firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with knurl balls
(E). Be sure studs (C) are fully seated in the knurl balls (E).
7. Refer to instructions following to install glass & bulb.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)