Hubbardton Forge 124251 - Manual

Installation Instructions
A221
For Moonband Semi-Flush 12-4251 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
23079
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install Fixture (Figure 1)
Component Parts
A Crossbar
B Ground
Screw
C Threaded Stud (2)
D Canopy
E Knurl
Balls (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (A) to match
hole centers in canopy (D). Move ground screw (B) to another
available threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar (A) to the
electric box using outer oval holes to orient fixture to desired hanging
position.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.
5. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to white or ribbed and black to black or smooth.
Connect all ground wires to green ground screw (B).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Slide fixture canopy (D) over threaded studs and push firmly to
ceiling, making sure that no wires are pinched between fixture canopy
and ceiling. Fasten with knurl balls (E). Be sure studs (C) are fully
seated in the knurl balls (E).
7. Refer to instructions following to install glass & bulb.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)