Hubbardton Forge 124247 - Manual (Page 2)

Installation Instructions
A34
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14532 Rev A
For Semi Flush Pendants with Slide Locking Mechanism Page 2 of 2
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Component Parts
K Notched Tab
L Fixed Stem
M Hooked Bar
N Ring Assembly
O Glass Bowl
To Install Glass
1. Install light bulb.
2. Place Glass Bowl (O) into ring assembly
3. Slide ring assembly onto fixed stem (L) of fixture.
The fixed stem should slide into the square hole in
the ring assembly (N).
4. Slide ring assembly horizontally to clear the socket
cup and rotate hooked bar (M) of ring assembly into
notched tab (K) in fixture centering the ring assembly
and glass.
Please Note: The glass in this fixture is hand blown which can cause imbalance in the total piece. While all care is taken
to limit the impact of the imbalance, sometimes the glass will hang off to one side. In order to correct for the issue, please
make sure the glass is placed in the holder with the same reveal all around the top ring. If the glass still hangs off, rotate
the glass 90 degrees in the holder to place the heavy side over one of the pivot points. This should resolve the tendency
of this hand craft glass to hang off to one side.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.