Hubbardton Forge 272820 - Manual

Shade Installation Instructions
C36
For Table Lamps 27-2820, 272820C, 28-2820, 28-2820C, 23-3050 & 23-3050C
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24829 A
To Install Glass Diffuser (Figure 1)
Component Parts
A Finial
B Washer
C Diffuser
D Shade
E Harp
F Socket
Knob
G Harp Holder
H Socket
I Locks
(2)
1. Carefully unpack the lamp from the carton.
2. Install socket knob (F) onto socket (Figure 1).
3. Remove finial (A) from harp (E) and save for later use. Finial is shipped
installed on harp.
4. Squeeze harp (E) together while holding the locks (I) up towards the top
of the harp (E) and slip into harp holder (G) (Figure 1).
5. Allow locks (I) to slip down harp (E) and onto harp holder (G) to secure
harp in place.
6. Install bulb. “C” version bulb is included.
7. Slip shade (D), diffuser (C) and washer (B) onto threaded stud on top of
harp (E). See Figure 3 for washer orientation.
8. Thread finial (A) onto threaded stud on harp (E) and tighten until snug.
Be careful not to over tighten.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 1
Figure 2
Figure 3