Hubbardton Forge 217510 - Manual (Page 2)

Installation Instructions
B176
For Aperture Sconce 21-7510 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22736 Rev A
To Install Front (Figures 3 & 4)
Component Parts
A Fixture Back
B Fixture Front
C Locking Screw
D Cap Screw (2)
J Bulb
(Included)
1. Install light bulb (J). Be careful not to touch bulb with bare hands; oil from your hands will reduce bulb life.
Note: When replacing the bulb it will be necessary to remove the glass on the right hand side to allow the front
assembly to be removed.
2. Slip fixture front (B) onto two cap screws (D) by aligning keyed slots with the cap screws (D) installed in fixture
back (A). When front assembly is as far back as it will go slide fixture to the right to secure.
3. Tighten locking screw (C) until snug. (Figure 4)
(continued)
(Figure 3) (Figure 4)