Hubbardton Forge 213310 - Manual (Page 2)

Installation Instructions
B256
Oculus Sconce/Semi-flush 21-3310 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27014
To Install Glass (Figure 3)
Component Parts
A Fixture
G Glass
H Threaded Stud (4)
I Rubber
Washer (8)
1. Install 2 rubber washers (I) onto
each threaded stud (H) and thread
the threaded studs (H) into the
blocks on the fixture (A). Be sure
to screw the studs (H) in far enough
so the glass will slip over.
2. Place glass (G) onto fixture (A).
Line up holes in glass (G) with
threaded studs (H).
3. Thread the threaded studs (H) out
evenly until the rubber washers (I)
fit snug against the glass. Be sure
not to over tighten.
To Install Bulb (Figure 4)
Component Parts
J Socket
K Bulb
(Included)
1.
Install light bulbs (K) into sockets (J). Be
careful not to touch bulb with bare hands;
oil from the hands will dramatically reduce
bulb life.
Note: The bulb included is based on our
design preference; see the fixtures wattage
sticker for Max wattage information.
( continued)
(Figure 4)
(Figure 3)