Hubbardton Forge 209310 - Manual (Page 2)

Installation Instructions
B93
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19433 Rev B
For Forged Bar Sconce 20-9310 & 20-9311 Page 2 of 2
6. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket and place the fixture over
the bracket so that the screws in the top of the bracket go through the holes in the top of the fixture. Secure the
fixture by threading the remaining black #8 screws up through the holes in the bottom of the fixture and into the
mounting bracket.
7. Install light bulb(s) and restore electricity at main breaker.
To Install Glass (Figure 3)
Component Parts
H Retaining Ring
I Glass
J Lamp
Socket
1. Place glass (I) over lamp socket (J).
2. Thread retaining ring (H) on to lamp socket (J) until it reaches the bottom
of the glass (I).
To Attach Shade (Figure 4)
Component Parts
I Glass
K Shade Clip (3)
L Shade
Spider
M Shade
1. Attach the (3) shade clips (K) to shade spider (L) leaving clearance for the edge of
the glass (I). Shade clip should push onto first curved area of spider.
2. Place shade so that shade spider rests on top edge of glass.
3. Slide shade clips out towards edge of glass equally to center the shade. Slide clips
until the notch engages with the top edge of the glass.
If you need further assistance, or find that you are missing any parts, please contact
the dealer from which you purchased this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 3)
(Figure 4)