Hubbardton Forge 207858 - Manual (Page 2)

Assembly & Installation Instructions
B117
For 20-7858 After Hours Wall Sconce Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19867 Rev B
To Install Glass Mounting Bracket (Figure 2)
Component Parts
G Glass
H Screw
I
Glass Mounting Bracket
1. Remove screw (B) from glass mounting bracket (C). Save for later use. Screw
is shipped installed in bracket.
2. Slide glass mounting bracket (I) inside end of the glass (G) that has drilled
hole.
3. Align small threaded hole in glass mounting bracket (I) with hole in glass (G).
4. Attach glass mounting bracket (I) to glass (G) with screw (H). Do not over
tighten.
To Install Glass to Fixture (Figure 3)
Component Parts
F Fixture
G Glass
J Nylon
Nut
K Threaded Rod
1. Remove nylon nut (J) from fixture and save for later use.
2. Align glass (G) so that mounting bracket is at the top of the glass.
3. Slide glass (G) over light bulbs until it stops at bottom of fixture (F).
4. Thread nylon nut (J) onto threaded rod (K) until tight.
Note: This fixture can be mounted as shown or in reverse.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hub bardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 2
Figure 3