Hubbardton Forge 204730 - Manual (Page 2)

Installation Instructions
B191
For Antasia Wall Sconce 20-4730F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22865
(Figure 2)
(Figure 3)
To Install Glass (Figure 2)
Component Parts
A Fixture Assembly
H Glass
I
½” Screw (2)
J Bracket
1. Loosen two ½" screws (I) shipped installed
in bracket (J). It is not necessary to remove
them completely.
2. Tilt and position glass (H) so it rests on
fixture assembly (A).
3. Tighten ½" screws (I) into bracket (J)
against glass (H) until snug. Be careful not
to over tighten.
To Install Diffuser
(Figure 3)
Component Parts
L Diffuser
M Bulb
(2)
N Socket (2)
O ¼” Screw
1. Install light bulb (M). Included with fixture.
2. Remove ¼" screw (O) shipped installed.
3. Install diffuser (L) onto fixture followed by ¼"
screw (O). Tighten screw until snug.
4. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.