Hubbardton Forge 203050 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
30763
Assembly & Installation Instructions
To Mount Fixture to 4” Box (Figure 2)
Component Parts
A Fixture
B Mounting Bracket
C Anchors (2)
D #10 Screws (2)
E Electric Box Cover (4” box)
F Cupped Washer
G Ground Screw
H #8 Black Screws (5)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Remove #8 black screw (H) from electric box cover (E).
Attach electric box cover (E) to wall mounting bracket (B)
using #8 black screw (H).
3. With a pencil, mark the location of all mounting holes in the
wall mount bracket (B) on the wall behind.
4. Drill 1/4" holes in the locations marked on the wall. For
holes using anchors, place the tapered end of the anchors
(C) into the holes and gently tap them flush to the wall using
a light weight hammer.
5. Thread the wires in the electrical box through the hole in the
wall mounting bracket (B) while moving the bracket into
position. Using the 1" #10 screws (D), screw the bracket
securely to the wall. Be careful not to over-tighten or strip
the anchors.
6. Hold the fixture (A) close to the mounting bracket (B) and
using suitable wire connectors (not provided) connect
fixture wires to supply wires (white to white and black to
black). Run a pigtail lead from the ground screw (G) and
cupped washer (F) to the electrical box and connect all
ground wires (bare copper or green to bare copper or
green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
7. Carefully tuck all wires behind the fixture (A) and inside the
mounting bracket (B). Place the fixture (A) firmly
onto bracket (B) and fasten with #8 black screws (H) on top.
8. Install two remaining black screws (H) in bottom of fixture
(A).
B318
Lisse Sconce 203050 Page 2 of 3
(Figure 2)
G
E
F
C
H
B
D
A
H