Hubbardton Forge 208021 - Manual

Installation Instructions
B240
Simple Lines Sconce 20-8021 Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26946
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Threaded Stud (2) F Socket
B Crossbar G Glass
C Ground Screw H Retaining Ring
D Fixture Assembly I Socket Tool
E Knurled Balls (2)
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (B) to the electric box making sure that
fixture mounting holes are level.
Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use with
the new fixture.
3. Thread studs (A) into the appropriate holes in the
crossbar (B). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall and
using suitable wire connectors, not provided,
connect fixture wires to supply (white to white or
ribbed and black to black or smooth). Run a pigtail
lead from crossbar ground screw (C) to the junction
box and connect all ground wires (bare copper or
green to bare copper or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (A) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurled balls (E). Be sure threaded studs (A) are fully seated in the
knurled balls (E).
6. Slide glass (G) over socket (F) and secure retaining ring (H) using the socket tool (I)
Note: Retain socket tool for future use.
7. Install light bulb (not included) and restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)