Hubbardton Forge 207523F - Manual (Page 2)

Installation Instructions
B127
For Ellipse Sconces 20-7523, 20-7523F, 20-7533 & 20-7533F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20990
7. Place the fixture over the bracket so that the screws in the top of the wall bracket go through the holes in the top
of the fixture. Pull the four supply wires and ground wires through the front wireway area. Secure the fixture by
threading the remaining black #8 screws up through the holes in the bottom of the fixture and into the mounting
bracket.
8. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white to white, black to
black, and bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
9. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket.
10. Install the wireway cover (H) and secure with barrel knobs (I).
To Install Glass (Figure 2)
Component Parts
J Socket (3)
K Glass (3)
L Retaining Ring (3)
M Socket
Tool
1. Slip glass (K) over socket (J).
2. Thread retaining ring (L) onto socket using socket tool
provided (M) until it rests on inside of glass (K). If socket
tool does not fit retaining ring tool can be adjusted by
squeezing to decrease inside diameter to better fit the
retaining ring. Do not over tighten.
3. Install light bulbs and restore electricity at main breaker.
(Figure 2)
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.