Hubbardton Forge 205950 - Manual (Page 2)

Installation Instructions
B270
Bento Sconce 205950F Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27718
6. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket and place the fixture over
the bracket so that the screws in the top of the wall bracket go through the holes in the top of the fixture. Secure
the fixture by threading the remaining black #8 screws (D) up through the holes in the bottom of the fixture and
into the mounting bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
To Assemble Shade (Figure 2)
Component Parts
H Shade
I
Plastic Rivet
1. Carefully unpack the shade (H)
2. Fold flaps (Figure 2) such that the three
holes are aligned
3. Insert plastic rivet (I) through the three holes
and cap on the back
4. Repeat steps 2 & 3 for other side of
shade (H)
To Install Shade (Figure 3)
Component Parts
J Upper Shade Bracket
K Fixture Bracket
L
#8 Black Screw (2)
M Lower Shade Bracket
H Shade
1. Install light bulbs (included)
2. Slip shade (H) onto lower shade brackets
(M)
3. Slide upper shade brackets (J ) in place
and fasten with #8 screws (L)
4. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)
(Figure 3)