Hubbardton Forge 204910 - Manual (Page 2)

Installation Instructions
B206
For Staccato Three Light Sconce 20-4910 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24451
5. Hold the fixture assembly (D) close to the wall mount bracket. Using suitable wire connectors (not provided),
connect fixture wires to supply wires (white to white or ribbed and black to black or smooth, and bare copper or
green to bare copper or green). Ground the mounting bracket using the green ground screw (G) and cupped
washer (H) to secure a pigtail lead to the bracket.
6. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket and place the fixture over
the bracket so that the screws in the top of the wall bracket go through the holes in the top of the fixture. Secure
the fixture by threading the black #8 x 3/4" screws (F) up through the holes in the bottom of the fixture and into
the mounting bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
To Install Glass (Figure 2)
Component Parts
I Socket (3)
J Bulb (3)(included)
K Retaining Ring (3)
L Glass
(3)
M Socket Tool
1. Remove retaining ring (K) from socket (I). Retaining ring is
shipped installed.
2. Install light bulb (J). Be careful not to touch bulb with bare hands;
oil from the hands will dramatically reduce bulb life.
3. Slip glass (L) over socket (I) and thread retaining ring (K) onto the
socket (I) using provided socket tool (M).
4. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)