Hubbardton Forge 204212 - Manual (Page 2)

Installation Instructions
B32
For One Light Wall Sconce 20-4012 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15020 Rev A
To Install Glass (Figure 2)
Component Parts
G Glass
H Socket
I Retaining
Ring
J Bulb Shield
K Bulb
L Socket
Tool
1. Remove retaining ring (I) from socket (H).
2. Slip glass (G) over socket (H).
3. Thread retainer ring (I) onto socket (H) until snug against
bottom of glass (G). Be careful not to over tighten
4. Install light bulb (K). Be careful not to touch bulb with bare
hands; oil from the hands will dramatically reduce bulb life.
5. Thread bulb shield (J) onto socket (H) (be careful not to over
tighten). Future bulb changes may be accomplished by
snapping glass portion of barrier on and off rather than
unthreading the holder.
6. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 2