Hubbardton Forge 207843 - Manual

Installation Instructions
B31
For Heavy Bracket Mounted Bath Style Fixtures
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Component Parts
A Wall Mount Bracket
B Anchors
C #10 Screws D Fixture
E #8 Black Screws
F Green Ground Screw G Cupped Washer
To Install
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture is heavy and must be securely fastened to at least one framing member.
1. Center the wall mount bracket (A) over the electrical box being sure to hold it plum and level. With a pencil, mark
the location of all mounting holes in the wall mount bracket on the wall behind. Put the wall mount bracket down
and drill 1/4" holes in the locations marked on the wall. It may be necessary to drill new holes in the mounting
bracket to allow for attachment to a framing stud. Place the tapered end of the anchors (B) into the holes and
gently tap them flush to the wall using a light weight
hammer.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14819 revC
2. Thread the wires in the electrical box through the
center hole in the wall mount bracket while moving
the bracket into position. Using the 1" #10 screws
(C), screw the bracket securely to the wall. Be careful
not to over-tighten or strip the anchors. Make certain
that bracket is attached directly to at least one framing
member.
3. Thread the black # 8 screws (E) up through the holes
in the top of the wall mount bracket. Leave the
bottom screws out for now.
4. Hold the fixture assembly (D) close to the wall mount
bracket and using suitable wire connectors (not
provided), connect fixture wires to supply wires (white to white, black to black, and bare copper or green to bare
copper or green). Ground the mounting bracket using the green ground screw (F) and cupped washer (G) to secure
a pigtail lead to the bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture assembly and inside the wall mount bracket and place the fixture over
the bracket so that the screws in the top of the bracket go through the holes in the top of the fixture. Secure the
fixture by threading the remaining black #8 screws up through the holes in the bottom of the fixture and into the
mounting bracket.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.