Hubbardton Forge 18775 - Manual (Page 2)

Assembly & Installation Instructions
A58
For Adjustable Pendant Models 18-773 & 18-775 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 16402 Rev A
To Install Glass (Please refer to Diagram 3.)
1. Unscrew locking nut (I) and slide locking nut, frame (K), and glass (J), small end up, up fixture stem.
2. While supporting glass and frame with one hand, place retaining spring (M) over socket and thread retaining ring
(O) onto socket until retaining ring is approximately halfway up socket.
3. Install bulb (P) in socket. Be careful not to touch bulb with bare hands. Oil from the hands will dramatically
reduce bulb life.
4. Thread glass shield (Q) onto socket just far enough to stay in place. Future bulb replacement can be accomplished
by snapping the glass from the holder rather than unscrewing the entire holder.
Caution: Keep glass shield in place when operating fixture.
5. Carefully lower glass, frame, and locking nut back into position and tighten locking nut, making sure glass and
frame are straight and level. Some adjustment of the retaining ring (O) may be required. If locking nut will not
start into the threads, adjust retaining ring lower on the socket. If threads are still showing when locking nut is
fully tightened, raise retaining ring on socket.
6. Restore electricity at main breaker box.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.