Hubbardton Forge 18455 - Manual (Page 2)

Assembly & Installation Instructions
A281
Adjustable Mobius Shade Pendant 18-455 Page 2 of 7
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26650
Complete Assembly & Install Fixture (Figures 3 & 4)
Component Parts
A Fixture Pipe
F Canopy
G Canopy Ring
H Canopy Pipe
I
Plastic Clutch Sleeve
J Clutch
K Set Screw
L
Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Place canopy (F) over canopy pipe (H), followed by canopy ring (G). Make
sure smaller diameter side of canopy ring is oriented up toward the canopy.
2. Thread wires from the fixture pipe (A) through the canopy pipe (H).
3. Unscrew the clutch (J) from the canopy pipe (H); slide it across the wires and
onto the fixture pipe (A). Follow this with the plastic clutch sleeve (I), oriented
so the tapered end of the clutch sleeve nests in the clutch. (Figure 3).
4. Slide the canopy pipe (H) as far as necessary to give you the total length of the
fixture which you desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (H). There must be a minimum 1-1/2"
of inner pipe inside the outer pipe. Hand-tighten the clutch to temporarily hold
this adjustment. The clutch is not securely fastened at this point; do not depend
on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 3).
5. Carefully slide canopy ring (G) and canopy (F) down over fixture pipe (A)
until they rest on the fixture.
6. Using two machine screws (not provided), fasten the crossbar to the electric
box. Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
7. Using suitable wire connectors (not provided), connect fixture wires to supply
wires (white to white supply, black to black supply). Run a pigtail lead from
crossbar ground screw (L) to the junction box and connect all ground wires
(bare copper or green to bare copper or green). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire
is exposed.
8. Slide fixture canopy (F) against ceiling, and secure with canopy ring (G).
9. Once the fixture is fastened to the ceiling, tighten the set screw (K) firmly with
hex wrench provided.
10. Refer to instructions below to install shade and light bulb.
(continued)
(Figure 3)
(Figure 4)