Hubbardton Forge 18761 - Manual (Page 2)

Assembly & Installation Instructions
A214
Antimeny Single Pendant 18-761 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22863
(Figure 3)
To Assemble Glass & Spider (Figure 3)
Component Parts
K Glass
L Spider
M Barrels
1. Place spider (L) into glass (K).
2. Secure glass to spider by threading barrels (M) through holes in glass and onto
legs of spider. Start all three barrels before tightening any individually.
To Install Glass (Figure 4)
Component Parts
N Glass Assembly
O Socket
P Retaining
Ring
Q Bulb (Included)
R Bulb Shield
1. Install light bulb (Q). Be careful not to touch bulb with bare hands; oil from the
hands will dramatically reduce bulb life.
2. Slip glass assembly (N) over socket (O) and thread retaining ring (P) onto socket
until snug.
3. Thread bulb shield (R) onto socket (O) (be careful not to over tighten). Future bulb
changes may be accomplished by snapping glass portion of barrier on and off
rather than unthreading the holder.
4. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 4)