Hubbardton Forge 144710 - Manual (Page 2)

Installation Instructions
A205
For Antasia Pendant 14-4710, 14-4710E, 14-4715 & 14-4715E Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22762
To Install Inner Glass (Figure 2)
Component Parts
I Socket
J Inner
Glass
K Retaining Ring
1. Remove retaining ring (K) from socket (I). Retaining Rings are shipped installed.
2. Place inner glass (J) over socket (I).
3. Replace retaining ring (K) and tighten to secure glass. Do not over-tighten.
4. Install light bulb. (Fluorescent bulbs included with fixture)
To Install Lower Glass (Figures 3 & 4)
Component Parts
L Arm Retaining Ring
M Arm
(3)
N Lower Glass
1. Loosen arm retaining ring (L).
2. Insert arms (M) into notches by angling the arms so they slip into
notches and pivoting them toward the center until they hang
vertical.
3. Slip lower glass (N) into the arms (M).
4. While supporting the glass tighten the arm retaining ring (L) until
snug. Caution: Arms can swing out causing glass to drop until
retaining ring is completely tight.
5. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts,
please contact the dealer from which you purchased this product. We
hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by
improper installation, lamping or use of this fixture.
(Figure 4)
(Figure 2)
(Figure 3)