Hubbardton Forge 138805 - Manual (Page 2)

Assembly & Installation Instructions
A333
Apparatus Pendant 138805 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28307
To Complete Fixture Assembly (Figure 2)
Component Parts
A Fixture
B Rod
C Ball
I Counterweight.
J Block
K Body
M Thumb Screw
N Thumb Screw (3)
P Glass
Q Bulb
R Shield
1. Install bulb (Q). Be careful not to touch bulb
with bare hands; oil from the hands will
dramatically reduce bulb life.
2. Screw shield (R) onto socket. Do not over
tighten.
3. Loosen the three thumb screws (N). It is not
necessary to remove them from the fixture.
4. Lower glass (P) into fixture body (K) and tighten
thumb screws (N) equally, until snug against
glass.
5. Remove ball (C) from rod (B). Loosen Thumb
screw (M) from block (J). Slide fixture body (K)
up onto rod (B), slipping the fixture body (K)
over the shield (R). Adjust to desired height and
tighten thumb screw (M).
6. Reattach ball (C) on rod (B)
7. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)