Hubbardton Forge 137525 - Manual (Page 3)

Assembly & Installation Instructions
A134
For Ellipse Pendants 13-7525, 13-7525F, 13-7535 & 13-7535F Page 3 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20928 Rev B
To Install to Ceiling
(Figure 5)
Component Parts
E Ceiling
Bracket
I Set Screw (2)
J Canopy
L Crossbar
M Stud
(2)
N Lag Screw (4)
O Threaded Stud (2)
P Hex Nut (2)
Q Barrel Knob (2)
1. Thread studs (O) through appropriate holes in crossbar
(L) to match holes in canopy (J).
2. Using two machine screws (not provided) fasten crossbar
(L) to the electric box using tab holes to orient fixture to
desired hanging position.
Note: A new electric box
comes with screws. When replacing an existing fixture,
retain the screws for use with the new fixture.
Alternate Mounting Option - Using four lag screws (N)
attach crossbar (L) to a structural member in the ceiling,
centering the crossbar over the outlet box. We've
supplied lag screws with your fixture; however, different
materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified
electrician.
3. Raise fixture to ceiling aligning studs in crossbar (L) with
holes in ceiling bracket (E).
4. Thread hex nut (P) onto studs (M) and tighten.
5. Using suitable wire connectors (not provided) connect
fixture wires to supply (white to white and black to black,
and bare copper to bare copper or green supply). Push
wires back into outlet box.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Raise canopy (J) to ceiling over threaded studs (O) and
push firmly to ceiling, making sure that no wires are
pinched between canopy and ceiling. Fasten with barrel
knob (Q).
Note: Be sure both swivel notches are aligned in the same direction. For sloped ceilings the notches should face
towards the down side.
7. Once the fixture is fastened to the ceiling, tighten the set screw (I) firmly with hex wrench provided. Only after the
set screw (I) is tight should you install the glass.
8. Refer instructions below and install glass.
(continued)
(Figure 5)