Hubbardton Forge 103250 - Manual

Installation Instructions
A137
For New Town Four Light Chandelier 10-3250 & 10-3255 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21137
To Install (Figure 1)
Component Parts
A Crossbar
B Lock
Nut
C Nipple
D Canopy
E Loop
Collar
F Canopy Loop
G Chain
H Fixture
Loop
I Fixture
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Thread the nipple (C) into the crossbar (A) and secure with lock nut
(B); slide canopy (D) over nipple, and attach the canopy loop (F) to the
nipple. Adjust the nipple to proper length to ensure a snug canopy fit
before proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the wire
through every other link of the chain (G) to the end. Slip wires and
chain through the collars and canopy (D, E & F). Fasten the chain to the
canopy loop, then slip wires through the loop and nipple, into the
electric box. Make sure to provide enough slack in the wire to ensure
weight of fixture is supported by the chain.
5. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture cord, black to smooth
side). Connect all ground wires to crossbar ground screw.
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Raise canopy to the ceiling and secure collar to canopy loop (F) with
loop collar (E).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)